Knowledge Base forRoland JP-80x0 Editor
Documentation
Resources
Roland JP-80×0 Editor – Sync Data From HW
This is the final step before you can start making your own adjustments IF “Enable Hardware Auto-connect” is disabled from Utilities menu as explained in previous section! Click Sync Data From HW [1] button to synchronize active PERFORMANCE data from your JP to the Editor user interface. This needs to be done only when new instance is loaded so that the Editor and you know what was set in the hardware already.
JP-80×0 Editor User Manual – Sync Data From HW
After the “Sync data from HW” process is completed, you should check the GENERAL SETTINGS [1] view. Verify layer MIDI channels are what you expect them to be.
JP-80×0 Editor User Manual – Check General Settings
You can now pursue with your own editing tasks, patch manipulations and experiments as you wish!
NOTE #1: Be patient and do not disturb the data flow with any knob movements or so. This will ensure the data packages are being sent and received as expected and you are not going to receive any SysEx error messages!
NOTE #2: All layers should ideally have individual MIDI channels to avoid control change conflicts. You can stack sounds together by setting the MIDI channel to same value, just keep in mind that control changes affect both layers!
Issues with hardware data sync? Check our FAQ before opening a ticket.
Share this with fellow producers
